Enfield-Rifles.com Homepage
Forum Home Forum Home > Enfields > Enfield Gunsmithing
  New Posts New Posts RSS Feed - If it ain't broke...
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

If it ain't broke...

 Post Reply Post Reply
Author
Message
Honkytonk View Drop Down
Senior Member
Senior Member
Avatar

Joined: December 30 2017
Location: Brandon Mb
Status: Offline
Points: 4770
Post Options Post Options   Thanks (0) Thanks(0)   Quote Honkytonk Quote  Post ReplyReply Direct Link To This Post Topic: If it ain't broke...
    Posted: May 20 2018 at 5:16am
After installing the new scope on a DAI Mgt mount, and a day at the range, I like the set-up. BUT... to make the mount stay tight, I used blue lock Tite to secure the big knobs to the mount. (Hard to explain unless you know the mount). When I went to clean the rifle, I realized I now can't remove the bolt as the peep site is still installed! I'll use a pull thru until the next time I completely disassemble. Dumb a#s!
Back to Top
Shamu View Drop Down
Admin Group
Admin Group
Avatar
Logo Designer / Donating Member

Joined: April 25 2007
Location: MD, USA.
Status: Offline
Points: 17603
Post Options Post Options   Thanks (0) Thanks(0)   Quote Shamu Quote  Post ReplyReply Direct Link To This Post Posted: May 20 2018 at 5:56am
OUCH!
Replace the bolts with hex bolts & TIGHTEN them with a wrench. (Then put the wrench in your range bag.)
Don't shoot till you see the whites of their thighs. (Unofficial motto of the Royal Air Force)
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.