Enfield-Rifles.com Homepage
Forum Home Forum Home > Enfields > Info for New Enfield Owners
  New Posts New Posts RSS Feed - S marked #111 bolthead.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Topic ClosedS marked #111 bolthead.

 Post Reply Post Reply
Author
Message
Tony View Drop Down
Moderator Group
Moderator Group
Avatar
Moderator

Joined: April 18 2006
Location: United Kingdom
Status: Offline
Points: 3256
Direct Link To This Post Topic: S marked #111 bolthead.
    Posted: December 23 2009 at 7:43pm
Captain Peter laidlers comment :
 

Spare bolt heads issued from the factory were actually oversize and marked with a small ‘S’….., but nobody can tell me by how much! Other Armourers of the period have told me, only yesterday over a frantic phone call, that this is incorrect but they WERE all to the longest specification. Whatever it is/was, there should be room to stone to size. And THIS is where Armourers were always taught DON’T OVER CHS. Or in this case, should that read don’t UNDER CHS. If your rifle closes on the .074” NO GO gauge, this is what you do. Go to the No1 bolt head drawer and select half a dozen bolt heads that don’t overturn by more than 10 degrees (later, 15 degrees was permitted to make best use of remaining spare parts stockpiles), the bolt face is not ringed sufficient to allow the escape of gas past the primer and the striker hole is not greater than .084” dia. Try them all until you get the best fit. If necessary machine or stone the bolt head square and true until it closes over the .064” gauge and doesn’t close over the .074” gauge. The point at which the bolt doesn’t close prior to the .050” limit is academic because so long as it doesn’t go/close, it’s passed the test.

Now, how you shorten the bolt head it is up to you. You can machine it in a lathe if you like but some are quite hard, or surface grind but I was taught that the best way was to rub the face down on a sheet of ‘400’ wet and dry carborundum paper on a sheet of glass, just covered in slow running water. Go round and round with equal pressure, rotating the bolt head slightly every so often, taking a gnats knacker off at a time for several minutes and trying it again and again. Every so often, smear a smidgin of engineers blue on the rear of the .074” gauge and close the bolt head lightly against it to ensure a crisp round witness mark on the face of the bolt. This is the acid test of it being perfectly square to the bore. Be sure to remember these old Armourers technical words such as ‘gnats knacker’ meaning something too insignificant to be measured and ‘smidgin’, indicating a quantity equivalent to a gnats knacker.

That is very basically it! Once again, this is weeks of practice in the classroom and on the bench with discussion groups all put into one short period. And if we destroyed a rifle or bolts and boltheads while learning our trade ….., who cared so long as we learned and got it right eventually.

Rottie (PitBulls dad.)


“If electricity comes from electrons, does morality come from morons

Born free taxed to death!!!

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.04
Copyright ©2001-2021 Web Wiz Ltd.