Enfield No 8, decocking question... |
Post Reply | Page 12> |
Author | |
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
Posted: December 06 2019 at 2:05pm |
Hi all. Lately I have been having a light strikes issue with my 1949 No 8 MKI 22 trainer. Normally, after a range session and before it goes back into the safe, I decock the rifle by holding the cocking piece and pulling the trigger as I ease it into the fired position. I am concerned that if this is not the correct way to decock the rifle that I may have been weakening one of the springs. Is this a possibility? I've not found anything in the manual that covers this, so if anyone has any advice or suggestions, it would be greatly appreciated. Thx Islandguy
|
|
Bear43
Special Member Donating Member Joined: August 11 2010 Location: Doland, SD Status: Offline Points: 3059 |
Post Options
Thanks(0)
|
With Enfields, just hold the trigger back when you are closing the bolt and it won't cock in the first place. Decocking is fine, the whole thing is that you just don't want to keep it stored cocked for long periods.
|
|
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
|
I've done that with the .303 Lee Enfields that I've owned in the past, but the Enfield No 8 is a cock-on-opening design.
|
|
The Armourer
Senior Member Joined: June 23 2019 Location: Y Felinhelli Status: Offline Points: 1246 |
Post Options
Thanks(1)
|
The No8 is not a standard type of cocking system - in fact the cocking is achieved by simply lifting and 'dropping' the bolt handle, there is no need to move the bolt at all (except for loading / ejecting). Islandguy : Have you looked at the tip of the striker ? is it the correct shape / length ? I don't know which manual you have but I have the War Office "Users Handbook" dated 1961, if you would like a copy drop me a PM with your email and I'll forward a copy to you. |
|
Stanforth
Senior Member Joined: January 08 2017 Location: Oxford England Status: Offline Points: 773 |
Post Options
Thanks(1)
|
As the Armourer says. lower the bolt steadily while holding the trigger back. That's what I do.
|
|
Life.. a sexually transmitted condition that is invariably fatal.
|
|
Bear43
Special Member Donating Member Joined: August 11 2010 Location: Doland, SD Status: Offline Points: 3059 |
Post Options
Thanks(1)
|
Ah, my mistake. I am not familiar with the No 8, as you can tell. Thanks for the correction.
|
|
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
|
Not to worry. The No 8 is a different kettle of fish than it`s bigger, older predecessors.
|
|
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
|
That`s the method I have been using. Just wanted to know if it was SOP for decocking the No 8. Thx Stanforth |
|
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
|
That is the same manual I have Armourer. Thx |
|
Zed
Special Member Donating Member Joined: May 01 2012 Location: France Status: Offline Points: 5585 |
Post Options
Thanks(0)
|
I think your procedure is OK. I just close the bolt with the trigger pulled back with my No8's as well. Have not had light srtike issues with the No8. What ammo are you using? I had a problem with my SMLE .22 and a change of ammo seems to have sorted the problem; as firing pin seems to be in spec'. |
|
It's nice to be important, but it's more important to be nice!
|
|
Stanforth
Senior Member Joined: January 08 2017 Location: Oxford England Status: Offline Points: 773 |
Post Options
Thanks(0)
|
I had light strike issues with my No.8 when I first got it but, with lubrication and use, they have gone away.
|
|
Life.. a sexually transmitted condition that is invariably fatal.
|
|
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
|
Sorry to have taken so long to get back to the thread guys. We had an aircraft crash on the island less than 150 meters from our house Tuesday evening, so it's been a bit hectic around here this week. Zed, I've been using CCI Std Vel ammo almost exclusively, and it has always been reliable and accurate. When I experience the misfires, it always detonates when I recock the rifle and try it a second time. I will give it a try with some different ammo. Stanforth, thanks for the tip. The bolt face was a bit crudded up, so I cleaned it and the rest of the action and will try it again next week when I have some time to get down to the range.
|
|
Shamu
Admin Group Logo Designer / Donating Member Joined: April 25 2007 Location: MD, USA. Status: Offline Points: 17603 |
Post Options
Thanks(0)
|
You might also try cleaning up inside the wood where the trigger mechanism lives. fossilized grease in there can cause similar problems.
|
|
Don't shoot till you see the whites of their thighs. (Unofficial motto of the Royal Air Force)
|
|
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
|
Hi all. Today was the first opportunity I've had to get the No 8 to the range. After thoroughly cleaning the bolt face and chamber area, the first and only 15 rounds fired discharged normally. The first 5 were warm-up rounds that registered 5 for 5 on a 2"dia. steel gong at 50 yards, and the 2nd 10 scored a ragged 100 on a NRA A-23 50 yard target, so it appears that the light strikes problem is solved. There was a significant build-up of "crud" on the bolt face before I began cleaning. Thanks for the tips. Much appreciated.
|
|
Zed
Special Member Donating Member Joined: May 01 2012 Location: France Status: Offline Points: 5585 |
Post Options
Thanks(0)
|
Thanks for the update; sounds like she's working just fine now.
These are great rifles; I do love shooting the .22's |
|
It's nice to be important, but it's more important to be nice!
|
|
islandguy
Groupie Joined: August 04 2015 Location: BC Canada Status: Offline Points: 33 |
Post Options
Thanks(0)
|
Yep, she works just fine now Zed. Had it down to the range yesterday and it shot really well, considering the wintery conditions. However, I'm getting an itchy trigger finger and would like to move onto another rifle, so my No 8 is going up for sale.
|
|
Post Reply | Page 12> |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |