Very New Enfield Owner, Help |
Post Reply | Page <123 |
Author | |
FrozenND
Groupie Joined: October 12 2018 Location: Fargo ND Status: Offline Points: 52 |
Post Options
Thanks(0)
|
I re looked at the lettering just above the rear trigger screw is the import markings I'm pretty sure of. I saw another Enfield on Gunbroker with the same letters in the same place. I took the photos of the other markings on the receiver, may not be the best. I think you can make them out. I haven't done anything with the rifle so far, was going to buy bullets, dies, brass next month. Just have to wait and see how everything goes right now. Thank you all for the well wishes for her, very nice of you all.
|
|
NJ
|
|
Goosic
Senior Member Joined: September 12 2017 Location: Phoenix Arizona Status: Offline Points: 8792 |
Post Options
Thanks(0)
|
Hope the wifey is doing well.
The first pic with the * stamped on the top of the receiver. Check the chamber and bore for any rust.
|
|
Zed
Special Member Donating Member Joined: May 01 2012 Location: France Status: Offline Points: 5585 |
Post Options
Thanks(0)
|
Looks like a very nice clean example of a Maltby made No4 Mk1 rifle. Personally I would not do anything to the wood other than a rub down with some linseed oil. I sure hope your wife will be OK. Good health is the most important thing you can have.
|
|
It's nice to be important, but it's more important to be nice!
|
|
Post Reply | Page <123 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |