Print Page | Close Window

Just waiting in the barrel...

Printed From: Enfield-Rifles.com
Category: Enfields
Forum Name: Enfield Rifles
Forum Description: Anything that has to do with the great Enfield rifles!
URL: http://www.enfield-rifles.com/forum_posts.asp?TID=10736
Printed Date: September 20 2020 at 8:30am
Software Version: Web Wiz Forums 12.01 - http://www.webwizforums.com


Topic: Just waiting in the barrel...
Posted By: Goosic
Subject: Just waiting in the barrel...
Date Posted: July 19 2020 at 6:09pm
I removed the old barrel and got down to focusing on improving the trigger pull. I started by putting a small bevel on the trigger and sear axis pin holes. I then stoned the sides of both so they can move freely without any friction during movement. The cocking piece, sear,and trigger contact points were then polished with a very fine jeweler's rouge.  The sear spring is out of a No1Mk111*. It still retains the two stages. However,because of how high a polish was achieved, it feels more like a single stage and the trigger pull is now a nice clean and consistent pull with a 36 ounce let off.
The scope bases are PH BA21 for the rear and a PH19 for the front. The scope rings are Bisley HT075 with 30mm main tube and a 17mm dovetail base with guide pins. The scope is a Lucid 6-24×50 with side focus...





Replies:
Posted By: WilliamS
Date Posted: July 19 2020 at 9:05pm
Looking good! Can't wait to see the finished rifle.  What furniture are you going with?


Posted By: Goosic
Date Posted: July 19 2020 at 9:12pm
A complete No4Mk2 furniture set. All walnut.



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.01 - http://www.webwizforums.com
Copyright ©2001-2018 Web Wiz Ltd. - https://www.webwiz.net