Print Page | Close Window

Addley Precision

Printed From: Enfield-Rifles.com
Category: Enfields
Forum Name: Enfield Gunsmithing
Forum Description: Submit any how-to's or other gunsmithing suggestions here.
URL: http://www.enfield-rifles.com/forum_posts.asp?TID=8817
Printed Date: November 19 2018 at 3:01am
Software Version: Web Wiz Forums 12.01 - http://www.webwizforums.com


Topic: Addley Precision
Posted By: Honkytonk
Subject: Addley Precision
Date Posted: March 10 2018 at 10:00am
Just ordered a new mount for my Enfield Parker Hale from Addley. I had saw on this forum there was a good discussion a few years ago on them. Sounded pretty positive. The current Sun Optics mount I have on it is flimsy and the forward three inches of rail are unsupported. Like a diving board. I can actually push down on the end of the scope and see it flex.



Replies:
Posted By: Canuck
Date Posted: March 10 2018 at 2:28pm
I have two of those mounts I swear by them. Very solidly built.

-------------
Castles made of sand slip into the sea.....eventually


Posted By: Honkytonk
Date Posted: March 10 2018 at 3:05pm
Thanks Canuck! Excited to get it!


Posted By: Macd
Date Posted: March 11 2018 at 5:46am
How far above bore will your centre of scope be with this mount?  I echo your comments on sun optics mount but the ADI I have is rigid.  I like the idea with the Addley mount about still being able to use the peep sights.


Posted By: Honkytonk
Date Posted: March 11 2018 at 5:51am
Macd, I haven't personally handled the Addley yet, but by appearances it looks to be about the same as the Sun Optics. I has already installed a walnut cheek piece to this rifle, so line of site will be excellent. The Addley mount required the ladder site to be removed (same as the Sun Optics which I already had removed) and they supply a peep that is part of the mount. It's calibrated to 300 yds, same as the original battle site.


Posted By: Goosic
Date Posted: March 11 2018 at 12:56pm
I had an Addley mount. I liked it. Reminded me of a PH mount. I also have a S&K mount I like better. It's shown here on my No5 for visual references​.


Posted By: Shamu
Date Posted: March 11 2018 at 2:48pm
The real problem is not with the scope height for a good weld, but as low as you can go without fouling the cocking piece when cycling the bolt, or bashing your thumb on the rear bell of the scope.
This was my best compromise.




-------------
Don't shoot till you see the whites of their thighs. (Unofficial motto of the Royal Air Force)


Posted By: A square 10
Date Posted: March 11 2018 at 5:24pm
nice looking setups , ive only got experience with a long ago gone mount this one looks quite nice , 



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.01 - http://www.webwizforums.com
Copyright ©2001-2018 Web Wiz Ltd. - https://www.webwiz.net